C Sort Flex-Flex Couplings
The C Variety coupling consists of two 
flex hubs, a single sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Form Flex-Rigid Couplings
The CFR Form coupling include a single flex hub, one rigid hub, a single sleeve, 1 accessory kit consisting of seals and snap rings.
Features
Very simple and cheap type of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Readily available as vertical and horizontal couplings
Broad variety of distinctive variations which include full-flex, flex-rigid mill motor
Common configurations are available of your shelf
Ordering Info
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so on.
Electrical power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance between shaft ends (BSE).
Shaft sizes.
C and CFR Style Couplings
Ordering Facts
Puller Holes are typical on sizes 4 through 12.
Puller Holes can be found for sizes 7/8 by means of 3.5 at an extra charge.
The BSE (distance Amongst Shaft Ends) may perhaps differ among G and G1.
Interference bores without any set screws are typical unless of course otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek the advice of Engineering Area.
More substantial sizes are available, please check with Technical Assistance.
C and CFR Kind Efficiency Information
Tags: