Power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
Standard Description
This energy unit is made solely for your smaller lift table,Consisting of higher strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has been extensively utilized while in the business of logistic units including minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed through the solenoid valve with the pace managed from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is intended exclusively to the medium lift table, Consisting of really effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve as well as the pace controlled from the adjustable needle valve. When the lift rises to a higher positoin, but the electrical power supply is cut, the reducing movement is controlled by the guide override function.
Electrical power UNITS FOR LIFT TABLE three
Common Description
This power unit is made exclusively for your massive lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the velocity managed by a pressure compensated movement control valve.
Energy UNITS FOR LIFT TABLE 4
Common Description
This energy unit is created exclusively for your massive lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived through the solenoid valve and the velocity controlled from the adjustable needle valve. Once the lift rises to a substantial positoin, but the electrical power supply is lower, the lowering motion is controlled through the guide override function.
Particular Notes
1. This electrical power unit is of S3 duty cycle, which might only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean each of the hydraulic components concerned just before installation of the energy unit.
3. Viscosity on the oil shoud be 15~46 cst,which need to also be clean and absolutely free of impurities.N46 hydraulic oil is advisable.
4. Oil modifying is required just after the original one hundred operation hrs,afterwards after every single 3000 hrs.
5. The electrical power unit proven is created to be mounted vertically.

Tags:

pto adapter

As one of leading pto adapter manufacturers, suppliers and exporters of mechanical products, We offer pto adapter and many other products.

Please contact us for details.

Mail:[email protected]

Manufacturer supplier exporter of pto adapter

Recent Posts