motor

Observing a handful of guidelines for appropriate installation is vital towards the reliable and good operation from the gearbox or gear motor.
The guidelines set out here are intended being a preliminary guidebook to choosing gearbox or gear motor. For powerful and right installation, comply with the instructions provided in the installation, use the maintenances manual for that gearbox accessible from our sales division.
Following is really a short outline of set up guidelines:
a) Fastening:
Area gearbox on a surface providing satisfactory rigidity. Mating surfaces must be machined and flat.
Mating surfaces need to be within definite geometric tolerances (see guide). This can be in particular accurate of flange-mounted gearboxes with splined hollow shafts.
In applications that involve higher radial loads with the output end, flange mounting is encouraged for some gearbox sizes as this mounting tends to make use of the double pilot diameters supplied in these gearboxes.
Make certain the gearbox is appropriate for the demanded mounting position.
Use screws of resistance class eight.8 and in excess of to secure the gearbox. Torque up screws towards the figures
indicated inside the relevant tables.
With transmitted output torque better than or equal 70% from the indicated M2max torque, and with
regular motion reversals, use screws with minimum resistance 10.9.
Some gearbox sizes might be fastened making use of either screws or pins. Of pin seated while in the frame the gearboxes be no less than 1.5 times pin diameter.
b) Connections
Safe the connection components to gearbox input and output. Will not tap them with hammers or similar resources.
To insert these elements, use the service screws and threaded holes provided about the shafts. Make sure you clean off any grease or protects in the shafts prior to fitting any connection components.
Fitting hydraulic motors.
Be cautious the O ring concerning motor flange and gearbox input flange when assembling. Install the
hydraulic motor in advance of filling lube oil to the gearbox.
Connecting the hydraulic brake.
The hydraulic circuit need to be such to ensure that brake is released instants in advance of gearbox commences and applied following gearbox has stopped. Check that strain in the hydraulic line for brake release is at zero every time gearbox is stopped.
Course of rotation
Motors are connected to the ideal electric or hydraulic circuit in line with their route of rotation.
When executing these connections, keep in mind that all gearboxes, regardless of whether within the in-line or proper angle design, have the exact same route of rotation each at input and output. For additional specifics of your connection of electric and hydraulic motors, see relevant sections on this catalogue.